More brands from

Close filters Show filters
More filters
Show less filters
  • Product
  • Wattage
  • Lamp Luminous Flux
  • IES
  • Leaflet

Sort by:

      Product family information

      Low-pressure mercury discharge lamp with a tubular 26mm envelope


      Longer lifetime and less early failures lead to less hassle and lower maintenance costs and facilitate the change from spot to group replacement
      Less waste and disposal cost at end-of-life
      Special fluorescent coating gives good colour rendering


      Significant reduction of early failures based upon a new technology (patent pending)
      Extreme long and reliable lifetime
      Highly efficient 3-band fluorescent coating in combination with New Generation pre-coating technology
      Low mercury dose for a long-life lamp (5 mg)
      Fully recyclable lamp technology
      End-cap has an x-shaped green bottom plate to distinguish lamp from other fluorescent lamps


      Suitable for use in applications where maintenance costs (high ceilings, difficult to reach) and disruptive costs are high (stopping of production process, closure of tunnels), or where lamp failure is not acceptable for e.g. safety reasons: tunnels, process, food and petrochemical industries

      Warning & Safety

      To achieve published lifetimes for 100% operation, do not dim below 30%
      When used on electromagnetic gear, it is strongly recommended to apply only Philips S10 or S10E starters (for 18W types S2 or S2E) to achieve the published lifetimes, and to install new starters when relamping.
      A lamp breaking is extremely unlikely to have any impact on your health. If a lamp breaks, ventilate the room for 30 minutes and remove the parts, preferably with gloves. Put them in a sealed plastic bag and take it to your local waste facilities for recycling. Do not use a vacuum cleaner.
      Product Data Sheet
      • Add product
      • Add product
      • Add product
      Add product

      Cannot find what you’re looking for?
      Perhaps one of these links might help